Contents x
      Initial Setup
      • 15 Jul 2024
      • 1 Minute to read
      • Contributors
      • Print
      • Dark
        Light
      • PDF
      Contents

      Initial Setup

      • Updated on 15 Jul 2024
      • 1 Minute to read
      • Contributors
      • Print
      • Dark
        Light
      • PDF
      Article summary

      Initial Setup

      1. Prepare the VODA mainboard, see Fig.1 and Fig.2 for top and bottom view
      USB Serial
      Fig.1 Top View
      USB Serial
      Fig.2 Bottom View
      1. Plug in the sensor cable, refer to Fig.3, Fig.4, and Fig.5
      USB Serial
      Fig.3 Sensor Cable
      USB Serial
      Fig.4 Sensor Board
      USB Serial
      Fig.5 Sensor to Main Board Connection
      1. Cover the tamper switch with any isolation/tape (preferably masking tape) as shown on Fig.6
      USB Serial
      Fig.6 Covered Tamper Switch
      1. Plug the battery to the main board as shown on Fig.7
      USB Serial
      Fig.7 Covered Tamper Switch
      1. Insert the sim card to the sim card slot
      2. Plug the serial cable to the PC (USB A interface)
      3. Plug another connector (USB C) to VODA serial port, see Fig.8 and Fig.9 below
      USB Serial
      Fig.8 USB Engineering Serial Cable
      USB Serial
      Fig.9 USB Serial Cable
      1. Run the desired script in "scripts/" directory
      py .\your_script.py
      1. If the response doesn't showed up, please try to flip the USB C and execute the scripts again.
      Was this article helpful?
      What's Next